Removal and Installation
REMOVAL
Remove rear door assembly. Refer to Removal and Installation.
Remove rear door hinge mounting bolts, and then remove rear door hinge from vehicle body.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Before installation, check the rear door hinge rotating part for lubrication condition. Refer to Inspection.
-
Before installation, apply anticorrosive agent onto the mounting surface.
-
When installation, perform the fitting adjustment. Refer to Adjustment.
-
After installation, apply touch-up paint (the body color) onto the head of rear door hinge mounting bolts and nuts.
-
After installation, check the open/close operation. Refer to Inspection.
-
After installation, apply anticorrosive around the bolts and nuts to prevent rust.
Other materials
Drive Belt
Exploded View
Idler pulley
Alternator
Drive belt auto-tensioner
Crankshaft pulley
A/C compressor
Water pump
Drive belt
A/C compressor belt
View
Indicator
Range when new drive belt is installed
Possible use range
Always replace after every ...
Fuel Pressure Check
Work Procedure
FUEL PRESSURE RELEASEFUEL PRESSURE RELEASE
Remove fuel pump fuse.
NOTE:
For the fuse number, Refer to Wiring Diagram.
For the fuse arrangement.
Start engine.
After engine stalls, crank it two or three times to release all fuel pressure.
Ignition switch OFF.
Reinstall f ...
Normal Operating Condition
Symptom Description
SYSTEM UNITLIQUID CRYSTAL DISPLAY Symptom Possible cause Possible solution
The screen is too dark.
The cabin temperature is too low.
Wait until the cabin temperature becomes moderate.
The cabin temperature is too hot.
Screen brightness is set to the maximum darkness ...