Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Shift to P”.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Set “Shift to P” in combination meter.
REPLACE BCM
-
Replace BCM. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
NVH Troubleshooting chartUse the Chart Below to Help You Find the Cause of the Symptom
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of the engine.
Check specified noise source.
If necessary, ...
Selective Unlock Function Does Not Operate
Diagnosis Procedure
CHECK “SELECTIVE UNLOCK” SETTING IN COMBINATION METER
Check “selective unlock” setting is ON.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “On” in combination meter.
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Remova ...
Rear Door Check Link
Removal and Installation
REMOVALFully close rear door glass.
Remove rear door woofer. Refer to Removal & Installation.
Remove rear door check link mounting bolt of vehicle body side.
Remove rear door check link mounting bolts of rear door panel, and then take rear door check link out from the ho ...