Nissan Armada 2025-2026 Service and Repair Manual: Precaution for Work
Disconnect battery negative terminal in advance.
When removing or disassembling any part, be careful not to damage or deform it. Protect parts, that may get in the way with a shop cloth.
When removing parts, use remover tool that is made of plastic.
When removing parts with remover tool that is not made of plastic, cover the toll surface with vinyl tape to protect parts.
Keep removed parts protected with a shop cloth.
If a clip is deformed or damaged, replace it.
If an unreusable part is removed, replace it with a new one.
Tighten bolts and nuts firmly to the specified torque.
After reassembly is complete, check that each part functions correctly.
Remove stains via the following procedure.
Water-soluble stains:
Dip a soft cloth in warm water, and then squeeze it tightly. After wiping off the stain, wipe with a soft dry cloth.
Oil stain:
Dissolve a synthetic detergent in warm water (density of 2 to 3%), dip the cloth, then wipe off the stain with the cloth. Next, dip the cloth in fresh water and squeeze it tightly. Then wipe off the detergent completely. Then wipe the area with a soft dry cloth.
Never use any organic solvent, such as thinner or benzine.
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open th ...
Other materials:
Diagnosis Procedure
CHECK SEAT CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Check driver seat control unit power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK POWER SEAT SWITCH GROUND CIRCUIT
...
Diagnostic Work Sheet
Description
INTERVIEW SHEET SAMPLE
Interview sheet Customer name MR/MS Registration number Initial year registration Vehicle type VIN Storage date Engine Mileage km/Mile Symptom □ Does not operate ( ) function □ Warning lamp for ( ) turns ON □ Noise           ...
General Specification
Applied model Axle 4WD Engine VR35DDTT Transmission A/T Rear final drive R240 with differential lock Propeller shaft model 2F C-C Number of joints 2 Joint type 1st joint Universal (Solid type) 2nd joint Universal (Solid type) Coupling method Transfer side Flange type Rear final ...
0.0068