
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Service Notice or Precautions for Steering SystemWork Procedure
CAUTION:
When after replacing audio amp, Configuration must be performed. Or not doing so, audio amp. control function does not operate normally.
REPLACE AUDIO AMP.
Replace audio amp. Refer to Removal & Installation.
>>
GO TO 2.
PERFORM AUDIO amp. CONFIGURATION
Perform audio amp. progra ...
Exploded View
Rear brake caliper Axle housing Bracket Parking brake actuator harness and rear wheel sensor : Vehicle front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb)
NOTE:
Rear RH wheel sensor is symmetrically opposite of LH. ...
Removal and Installation
WARNING:
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Drain gear oil. Refer to Draining.
Remove front stabilizer clamps. Refer to Removal and Installation.
Remove both front drive shafts. Refer to Removal and Installation.
CAUTION:
Oil may leak from the opening. Use ...