Nissan Armada 2025-2026 Service and Repair Manual: Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment.
Observe the following precautions when disassembling.
Before disassembly, thoroughly clean the outside of the unit.
Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter.
For easier and proper assembly, place disassembled parts in order on a parts rack.
Use nylon cloth or paper towels to clean the parts; common shop rags can leave lint that might interfere with their operation.
Never reuse non-reusable parts.
Before assembling, apply the specified grease to the directed parts.
During quick steering, rasping noise may be heard from around the steering wheel. This is not a malfunction. The noise is an operating noise of the EPS system under normal conditions. If the rasping noise occurs during slow steering, this may not be an operating noise of the system. In this case, it is necessary to find out the location of the noise and repair, if necessary.
Never repeat static steering. (Motor and EPS control unit could be heated.)
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open th ...
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
System
WARNING:
CAUTION:
OPERATION PROCEDURE
Jacking up or lift up using the following steps.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Jacking up or lif ...
Other materials:
Removal and Installation
CAUTION:
Perform work with 2 workers, because it is heavy weight.
Support back door with a proper material and use protective tape or shop cloth to protect back door and body from falling and damage when removing and installing spindle unit.
REMOVAL
Disconnect battery cable from 12V battery negativ ...
Removal and Installation
CAUTION:
Never damage the body panel.
REMOVAL
Apply protective tapes (A) on assist grip to protect it from damage.
Disengage assist grip cap fixing pawls of assist grip using a remover tool (A), and then remove assist grip cap of assist grip.
: Pawl
Remove assist grip mounting bolts, and then ...
NVH Troubleshooting Chart
Possible cause and suspected parts SYMPTOM Reference Noise Shake Vibration Shimmy Judder Poor quality ride or handling Improper installation, looseness × × × × × × REAR SHOCK ABSORBER: Exploded View
FRONT LOWER LINK: Exploded View
REAR LOWER LINK AND COIL SPRING: Exploded View
...
0.0104