Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precautions for Body Repair
WARNING:
WARNING:
The repair information in this section is intended for trained body repair technicians who have attained a high level of skill and experience (e.g. ASE Collision Repair Certification ...
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
System
WARNING:
CAUTION:
OPERATION PROCEDURE
Jacking up or lift up using the following steps.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Jacking up or lif ...
Other materials:
Frame Repair Method according to Deformation Type
The basic repair procedures are described below for the respective frame deformation types previously outlined.
(1) SAGGING REPAIR METHOD
For sagging, any vertical bending of the frame must be straightened. The entire frame must be measured accurately to see if only a single side of the frame is dis ...
Removal and Installation
REMOVAL
Rear Door Sash Cover Front
Remove rear door outside molding. Refer to Removal and Installation.
Remove rear door glass run of upper side. Refer to Removal and Installation.
Remove rear door weather-strip of upper side. Refer to Removal and Installation.
Apply protective tape (A) on the part ...
Precaution for Automatic Brake Hold
Do not disassemble chassis control module.
Do not use any parts that have been dropped.
Do not perform active test during driving.
Do not operate automatic brake hold function on a steep slope or a slippery road. (The vehicle may move even when automatic brake hold function is applied.)
When the sto ...
0.0052