Nissan Armada 2025-2026 Service and Repair Manual: Precaution for Automatic Brake Hold
Do not disassemble chassis control module.
Do not use any parts that have been dropped.
Do not perform active test during driving.
Do not operate automatic brake hold function on a steep slope or a slippery road. (The vehicle may move even when automatic brake hold function is applied.)
When the stopped condition of the vehicle cannot be maintained by automatic brake hold function, depress brake pedal to maintain the stopped condition.
Master warning lamp (yellow) illuminates if a malfunction occurs in automatic brake hold function. A pop-up screen also appears. Refer to Chassis Control Warning.
When the vehicle is moved or may start moving while automatic brake hold function is being applied,master warning lamp (red) illuminates, and a warning chime sounds at the same time. A pop-up screen also appears. Refer to Automatic Brake Hold Warning.
Be sure to deactivate automatic brake hold function when using a car wash machine, towing your vehicle or overloaded.
Automatic brake hold function will not be activated when the vehicle is in the 4L position.
If 4WD shift switch is shifted to 4L position when automatic brake hold function is activated, the braking force of automatic brake hold function will be released.
When parking the vehicle, with shift position is in P and apply electric parking brake.
When getting on the vehicle or when loading/unloading a cargo, with shift position is in P and apply electric parking brake.
When VDC warning lamp, brake system warning lamp, or electric parking brake warning lamp is illuminated, or chassis control warning (automatic brake hold function) message appears, automatic brake hold function does not operate.
Automatic brake hold function retains the last state until the driver changes the option even if the ignition switch OFF.
Automatic brake hold function is operated by applying sufficient braking force to hold the vehicle in its place, so there are cases when this hold function is maintained even if the accelerator pedal is depressed. In this situation, it is advised to depress the brake pedal first, then to turn OFF automatic brake hold switch. This will cancel the hold function.
While automatic brake hold function is being applied, the system may apply the brakes to maintain the stopped condition of the vehicle.
At this time, a operating noise may be generated. These are not symptoms of malfunctions and indicate normal operating conditions.
If the switch indicator does not illuminate after operating automatic brake hold switch, inspect brake control system and electric parking brake system in addition to automatic brake hold function.
If parts of related to automatic brake hold function are replaced, check automatic brake hold switch indicator can turns ON/OFF.
Parts of related to automatic brake hold function: Refer to System Description.
Precautions for Harness Repair
Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.
NOTE:
...
Wiring Diagram
...
Other materials:
Exploded View
Back door panel Back door finisher upper Back door finisher Back door opener switch : Clip : Pawl ...
Removal and Installation
CAUTION:
Always work with a helper.
When removing/installing moonroof unit assembly, use cloths to protect the seats and trim from damage.
REMOVAL
Remove wind deflector. Refer to Removal and Installation.
Remove glass lid. Refer to Removal and Installation.
Remove headlining. Refer to Removal and I ...
When SRS is activated in a collision
CAUTION:
Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles.
WORK PROCEDURE
Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
Replace the diagnosis sensor unit.
Remove the front a ...
0.0049