
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Wiring DiagramService Notice or Precautions for Front Final Drive
Use recommended gear oil only .Refer to Fluids and Lubricants.
Check for the correct installation status prior to removal or disassembly. If matching marks are required, be certain they never interfere with the function of the parts when applied.
Overhaul should be done in a clean work area, it is p ...
Exploded View
Transfer assembly Input oil seal : Vehicle front : Always replace after every disassembly. : Apply transfer fluid. ...
Diagnostic Work Sheet
DESCRIPTION
There are many operating conditions that lead to the malfunction of engine components. A good grasp of such conditions can make troubleshooting faster and more accurate.
In general, each customer feels differently about an incident. It is important to fully understand the symptoms or co ...