Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
WARNING:
Always observe the following items for preventing accidental activation.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
Always observe the following items for preve ...
Wiring Diagram
...
Other materials:
Principle
A special highly elastic resin has been combined with a conventional clear coat to increase the paint's flexibility. This has also increased its strength by raising the resin density.
The paint does not self-repair if scratches are deep enough to sever the bonds within the clear coat or if the clea ...
Diagnosis Procedure
CHECK SLIDING MECHANISM
Check for the following.
Mechanism deformation or pinched foreign materials.
Interference with other parts because of poor installation.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK SLIDING SWITCH
Check ...
Removal and Installation
WARNING:
REMOVAL
Ignition coil
NOTE:
No. 2-No. 5 can be removed using only the ignition coil.
Remove engine cover. Refer to Removal and Installation.
Remove mounting bolt from air inlet tube 1 . (No. 1 and No. 6 cylinder)
: Vehicle front
Remove mounting bolt from air inlet tube 1 . (No. 1 and ...
0.0052