
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
SystemDiagnosis Procedure
CHECK REAR POWER WINDOW SWITCH LH GROUND CIRCUIT
Check rear power window switch LH ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK REAR POWER WINDOW SWITCH LH
Check rear power window ...
EVAP CANISTER : Inspection
Check EVAP canister as per the following:
Block port .
Blow air into port and check that it flows freely out of port .
Release blocked port .
Apply vacuum pressure to port and check that vacuum pressure exists at the ports and .
Block port and .
Apply pressure to port and check that there is ...
Precaution for Electronic Air Suspension System
WARNING:
When jacking up or lift up the vehicle, always turn OFF the electronic air suspension function with the vehicle unladen and normal height, since the suspension may accidentally move and it can lead to personal injury. Refer to the operation procedures on the reference to set normal height a ...