
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Wiring DiagramPaint Safety Precautions
Observe the following precautions to maintain a safe painting work area.
Wear an approved respirator and eye protection when painting.
Wear approved gloves and appropriate clothing when painting. Avoid contact with skin.
Spray paint only in a well-ventilated area.
Cover spilled paint with sand or an ...
Inspection and Adjustment
INSPECTION
Brake Pedal Height
Check the height (H1) between the floor panel and the brake pedal upper surface.
H1 : Refer to Brake Pedal.
CAUTION:
Remove the front floor carpet.
Stop Lamp Switch
Check the clearance (A) among the brake pedal lever and the stop lamp switch mounting bracket .
...
Inspection
INSPECTION AFTER REMOVAL
Move joint up/down, left/right, and in the axial direction. Check for any rough movement or significant looseness.
Check boot for cracks or other damage, and also for grease leakage.
If a malfunction is found, disassemble drive shaft, and then replace with new one.
INSPECT ...