When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil.
Unladen conditions mean that fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
After servicing suspension parts, be sure to check wheel alignment.
Self-lock nuts are not reusable. Always use new ones when installing. Since new self-lock nuts are pre-oiled, tighten as they are.
Precaution for Electronic Air Suspension System
Precautions for Removing Battery TerminalWork Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Ignition switch ON.
Perform writing vehicle specification to BCM following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.
NOTE:
Log in the network according to CONSULT guidance.
>>
WORK END ...
Removal and Installation
REMOVAL
Remove back door trim. Refer to Removal and Installation.
Remove mounting nuts .
Remove mounting bolts .
Disconnect rear washer tube C .
CAUTION:
When washer tube is disconnected, washer fluid may come out so prepare a container to receive washer fluid and never allow washer fluid to b ...
Precaution for Electronic Air Suspension System
WARNING:
CAUTION:
Never expand and contract the air spring of shock absorber.
Never expand and contract the air spring.
Never let foreign materials entered into parts.
Always check for the air leakage with soapy water after working.
Be sure to close the hood after working.
Air suspension component p ...