Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Check oil level from filler plug mounting hole as shown in the figure after removing filler plug
and gasket from final drive assembly.

CAUTION:
The ignition switch OFF while checking oil level.
-
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Draining
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
The ignition switch OFF.
Remove drain plug
and gasket.

Drain gear oil.
Set a gasket on drain plug and install it to final drive assembly.
CAUTION:
Never reuse gasket.
Tighten drain plug to the specified torque. Refer to Exploded View.
Refilling
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
Remove filler plug
and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.

| Recommended oil and capacity | Refer to Fluids and Lubricants. |
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Other materials
Vr35ddtt
Starter Motor
Engine
VR35DDTT
Type
M001TF1771
MITSUBISHI make
Reduction gear type
System voltage
(V)
12
No-load
Terminal voltage
(V)
11
Current
(A)
Less than 110
Revolution
(rpm)
More than 2,890
Clearance "L" between pinion front edge and pinion stopper
...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Steering Column Control Module
Removal and Installation
REMOVALRemove instrument lower panel LH. Refer to Removal and Installation.
Remove steering column control module bracket mounting screw .
Disconnect steering column control module connector.
Remove steering column control module.INSTALLATIONNote the following items, and t ...