NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Side Oil Seal

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Driveline. Rear Final Drive: R240 / Side Oil Seal

Exploded View

Rear final drive assembly Side oil seal    
: vehicle front
: Always replace after every disassembly.

Removal and Installation

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

Remove rear final drive assembly. Refer to Removal and Installation.

NOTE:

It is necessary to remove rear final drive assembly to remove/install the side oil seal.

Remove side oil seal, using side oil seal puller (A) [SST: KV10122000 (NI-53383)] and sliding hammer (B) (commercial service tool).

CAUTION:

Never damage gear carrier.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • Install side oil seal until it becomes flush with the case end, using the side oil seal installer (A) [SST: KV10123000 (NI-53384)].

    CAUTION:

    • Never reuse oil seal.

    • When installing, never incline oil seal.

    • Check that the oil seal lip is filled up with grease.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER INSTALLATION

Check the oil level and the oil leakage after installation. Refer to Inspection.

    Other materials

    Configuration (air Bag Diagnosis Sensor Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the air bag diagno ...

    Led Headlamp Operation Inspection
    Work Procedure CHECK START In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time. In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable s ...

    Precautions
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...