Removal and Installation
CAUTION:
Never damage rear door panel.
REMOVAL
CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
Fully open rear door.
Remove pull handle cap.Apply protective tape (A) on rear door finisher to protect it from damage.
Remove rear door finisher fixing screws 
.
Remove inside handle cap.Apply protective tape (A) on inside handle to protect it from damage.
 |
: Pawl |
Remove rear door finisher mounting bolt .
Apply protective tapes (A) on rear door sash inner cover to protect it from damage.
Apply protective tape (A) on rear door panel to protect it from damage.
Disengage rear door finisher fixing clips using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure.
CAUTION:
Insert a remover tool between rear door panel and clip to prevent damage to the parts, and then disengage clips.
 |
: Clip |
Disconnect each rear door harness connector from rear door finisher.
Disconnect inside handle cable 
from inside handle according to numerical order 1→2 indicated by arrows as shown in the figure.
Disconnect lock knob cable from rear door finisher according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove rear door finisher.
Remove pull handle bracket fixing screws , and then remove pull handle bracket.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Visually check clips for deformation and damage during installation. Replace with new ones if necessary.
-
Check in advance that clips are accurately aligned with the portions on rear door panel, and then install by pressing in.
-
Tighten rear door finisher mounting bolt
to the specified torque. Refer to Exploded View (rear door inside handle part).
Other materials
Seat belt extenders
If, due to body size or seating position, the standard lap-shoulder belt in the
Nissan Armada cannot be comfortably or properly fastened, a compatible seat belt
extender is available. This accessory is specifically designed to work with the
original seat belt system installed in the Nissan Arm ...
SAND mode
WARNING
When SAND mode is activated in the Nissan Armada, the Vehicle Dynamic Control
(VDC) system operates with reduced intervention. As a result, the system may not
react in the same way as it does in STANDARD mode. To minimize the risk of accidents,
always drive the Nissan Armada with caut ...
General Precautions
GENERAL PRECAUTIONS : Precautions
Always use a 12 volt battery as power source.
Never attempt to disconnect battery cables while engine is running.
Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so ma ...