Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
MOUNTING INSPECTION
Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal.
WHEEL BEARING INSPECTION
-
Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel hub and bearing assembly.
Axial end play : Wheel Bearing -
Rotate wheel hub and bearing assembly, and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.
Other materials
Condenser Inlet Pipe
Removal and Installation
REMOVALCAUTION:
Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation.
When disconnec ...
Intelligent Key Button Operation Has Poor Range (all Keys)
Description
Intelligent Key button operation has poor range.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of tr ...
Wireless Charger Unit
Removal and Installation
REMOVALRemove the front center console cup holder assembly. Refer to Removal and Installation.
Remove the center console pocket mat. Refer to Exploded View.
Press the wireless charger unit pawl from the back of the front center console cup holder assembly to remove the wirel ...