WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove glove box cover. Refer to Removal and Installation.
Disconnect transfer control unit harness connector.

INSTALLATION
Note the following, and install in the reverse order of removal.
Exploded View
4wd Shift SwitchInspection
WARNING:
LOOSENESS OF CONNECTED PART
BACKLASH OF JOINT PART
BACKLASH OF CENTER BEARING
Move the shaft near center bearing up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the bearing has no backlash. If the bearing has a malfunction, remove propell ...
Special Service Tools
The actual shapes of the TechMate tools may differ from those of the special service tools illustrated here.
Tool number
(TechMate No)
Tool name Description KV10111100
(NI-37228)
Seal cutter
Removing carrier cover ST30720000
(NI-25405)
Drift
a: 77 mm (3.03 in) dia.
b: 55.5 mm (2.185 in) dia.
In ...
Diagnosis Procedure
PERFORM ECM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “ECM”.
Is any DTC detected?
YES >>
Check DTC detected item. Refer to DTC Index.
NO>>
GO TO 2.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for "AWD/4WD".
Is any DTC detected?
YES>>
Check the DTC ...