WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector
.

Remove harness clip
.

Remove transfer control actuator mounting bolt (
) and remove bracket
.

Remove transfer control actuator
.

INSTALLATION
Note the following, and install in the reverse order of removal.
Never damage oil seal of transfer control actuator.
Never contaminate or damage the oil seal mounting surface.
Perform inspection after installation. Refer to Inspection.
Exploded View
InspectionPrecaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is inclu ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Diagnosis Procedure
CHECK DTC WITH AIR BAG DIAGNOSIS SENSOR UNIT
Check that DTC is not detected with air bag diagnosis sensor unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK COMBINATION METER
Check combination meter. Refer to Work flow.
Is the inspection result normal? ...