
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"Removal and Installation
REMOVAL
Disconnect the battery cable from the negative terminal.
Remove display unit display unit finisher RH and LH. Refer to Removal and Installation.
Remove display unit cover. Refer to Removal and Installation.
Remove the mounting screws of the display unit .
Pull the display unit upward, the ...
Diagnosis Procedure
CHECK SEAT CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Check driver seat control unit power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK POWER SEAT SWITCH GROUND CIRCUIT
...
Exploded View
Drive pinion lock nut Companion flange Front oil seal Pinion front bearing Collapsible spacer Gasket Filler plug Drain plug Mounting insulator Gear carrier Mounting insulator Breather connector Side shaft bearing Snap ring Snap ring Side oil seal Side shaft Pinion rear bearing Pi ...