REMOVAL
Remove headlining assembly. Refer to Removal and Installation.
Remove fixing screws
and disengage metal clips
, and then remove rear ventilator grille housing.

Disengage fixing metal clips
, and then remove rear ventilator grille.

INSTALLATION
Install in the reverse order of removal.
Exploded View
Body side outer panel Side window glass Glass primer Adhesive Edge Adhesive mark : Clip : Always replace after every disassembly.
Unit: mm (in)
Portion Primer range Adhesive range L N Side window glass - Body side outer panel - F From edge, more than 20.0
(0.79) 7.0 + 2.0, - 0.0
(0. ...
Removal and Installation
REMOVAL
Remove rear bumper energy absorber. Refer to Removal and Installation.
Remove harness clip .
Disconnect outside key antenna (rear bumper) harness connector.
Remove outside key antenna (rear bumper) fixing nuts , and then remove outside key antenna (rear bumper) .
INSTALLATION
Install in th ...
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...