REMOVAL
Remove TORX bolts, and then remove front door striker.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Never reuse TORX bolt. Always replace it with a new one when it is removed.
Before tighten front door striker mounting TORX bolts to the specified torque, perform the fitting adjustment. Refer to Adjustment.
Front Door HingePrecaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is inclu ...
PARTS REQUIRING ANGLE TIGHTENING
Use the angle wrench [SST: KV10112100 (BT-8653-A)] for the final tightening of the following engine parts:
Camshaft sprocket (INT) bolt
Cylinder head bolts
Main bearing cap bolts
Connecting rod cap bolts
Crankshaft pulley bolt (No the angle wrench is required as bolt flange is provided with notches ...
Turning the AEB with Pedestrian Detection system ON/OFF
AEB system OFF warning light (on the meter panel)
Vehicle information display
Steering-wheel-mounted controls (right side)
In the Nissan Armada, the Automatic Emergency Braking (AEB) with Pedestrian Detection
system can be enabled or disabled through the vehicle information display. ...