Inspection
For front seat belt illustration. Refer to Exploded View.
For second seat belt illustration. Refer to Exploded View.
For third seat belt illustration. Refer to Exploded View.
CAUTION:
-
After any collision, inspect all seat belt assemblies, including retractors and other attached hardwares (I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt assemblies in use during a collision, unless not damaged and properly operating after minor collision.
Also inspect seat belt assemblies not in use during a collision, and replace if damaged or improperly operating.
Seat belt pre-tensioner should be replaced even if the seat belts are not in use during a frontal collision where the driver and passenger air bags are deployed.
-
If any component of seat belt assembly is questionable, do not repair.
Replace as seat belt assembly.
-
If webbing is cut, frayed, or damaged, replace belt assembly.
-
Never oil tongue and buckle.
-
Use a genuine NISSAN seat belt assembly.
For details, refer to Inspection, Inspection, Inspection in SB section.
-
Check anchors for loose mounting
-
Check belts for damage
-
Check retractor for smooth operation
-
Check function of buckles and tongues when buckled and released
Other materials
Lumbar Support Unit
Removal and Installation
REMOVALRemove front seatback blower motor. Refer to Removal and Installation.
Disengage fixing portions and then remove front seat lumbar support unit.
Disconnect front seat pneumatic control unit connector (4 way lumbar support) or front seat lumbar support air pump conn ...
Approach Unlock/walk Away Lock Function Does Not Operate (all Keys)
Description
Approach unlock/walk away lock function does not operate.NOTE:
Before starting diagnosis check that vehicle condition is as shown in “Conditions of vehicle”, and check each symptom.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) ...
Vin Registration
Work Procedure
VIN Registration is an operation to register the VIN in ADAS control unit.CHECK VIN
Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .
>>
GO TO 2 .
PERFORM VIN REGISTRATION
With CONSULT
Ignition switch ON.
...