Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Vin Registration

Work Procedure

VIN Registration is an operation to register the VIN in ADAS control unit.

CHECK VIN

Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .

>>

GO TO 2 .

PERFORM VIN REGISTRATION

With CONSULT

  1. Ignition switch ON.

    CAUTION:

    Never select READY

  2. Select “VIN registration” at "WORK SUPPORT" mode on the CONSULT screen.

  3. Follow the instructions on the CONSULT screen.

>>

END

Work Procedure

VIN Registration is an operation to register the VIN in ADAS control unit.

CHECK VIN

Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .

>>

GO TO 2 .

PERFORM VIN REGISTRATION

With CONSULT

  1. Ignition switch ON.

    CAUTION:

    Never select READY

  2. Select “VIN registration” at "WORK SUPPORT" mode on the CONSULT screen.

  3. Follow the instructions on the CONSULT screen.

>>

END

    Other materials

    Rear Axle Service Data and Specifications
    Wheel Bearing Item Standard Axial end play 0.05 mm (0.002 in) or less Drive Shaft With differential lock Item Standard Grease quantity Wheel side 155 - 175 g (5.47 – 6.17 oz) Final drive side 310 - 330 g (10.94 – 11.63 oz) Boots installed length Wheel side 143.6 mm (5 ...

    Seat Reclining
    Diagnosis Procedure CHECK RECLINING MECHANISM Check for the following. Mechanism deformation or pinched foreign materials. Interference with other parts because of poor installation. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. ...

    Ign Off Interlock Door Unlock Function Does Not Operate
    Diagnosis Procedure CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER Check “Auto Door Unlock” setting is “Ignition OFF”. Is the inspection result normal? YES>> GO TO 2. NO>> Set “IGN OFF” in combination meter. REPLACE BCM Replace BCM. Refer to Removal and Install ...