Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to Removal and Installation.
Remove steering angle sensor from spiral cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
When replacing the angle sensor
, if the lock pin 
is installed, remove the lock pin after installing the angle sensor to the spiral cable.
CAUTION:
Perform steering angle sensor neutral position adjustment when steering angle sensor is removed and installed, or replaced. Refer to Work Procedure.
Other materials
Basic information
The Vehicle Dynamic Control (VDC) system in the Nissan Armada is an advanced
stability and traction management system that continuously monitors driver inputs
and vehicle behavior through multiple sensors. By analyzing steering input, wheel
speed, and vehicle motion, the Nissan Armada VDC syst ...
Around View Monitor Tools and Preparation
Preparation
Commercial Service Tools
Tool Description
Power tool
Loosening screws
Special Service Tools
Tool number
(TechMate No.)
Tool name Description
KV9912-0000
(—)
Laser marker
Use for calibration
...
Action Test
Ldw
Work Procedure
Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.CAUTION:
Fully understand the following items ...