| Symptom | Possible cause | Inspection item | |||
|---|---|---|---|---|---|
| All function does not operate |
| Check power supply and ground circuit (third seat control unit)
| |||
| Manual function does not operate normally | Manual function does not operate |
| Check third seat reclining switch Refer to Component Function Check. | ||
| Check third seat reclining motor Refer to Component Function Check. | ||||
| Motor operates but stops immediately when the manual function is operated |
| Check third seat reclining sensor Refer to Component Function Check. | |||
| Narrow motor operating range when the manual function is operated | Seat position recognition position is misaligned | Perform third seat position initialization
| |||
| Slow motor operation speed when the manual function is operated |
| Check third power seat mechanism | |||
| 12V battery system | Check 12V battery | ||||
| Folding function does not operate normally | Folding function does not operate | Folding switch operation | Check third power seat manual function does it operate normally | ||
| Check folding switch Refer to Component Function Check. | ||||
| Only the display unit operation does not operate | Check AV system | ||||
| Narrow motor operating range when the folding function is operated | Seat position recognition position is misaligned | Perform third seat position initialization
| |||
| Slow motor operation speed when the folding function is operated |
| Check third power seat mechanism | |||
| 12V battery system | Check 12V battery | ||||
| Unintentional operation of the anti-pinch function | Seat position recognition position is misaligned | Perform third seat position initialization
| |||
| Seat buzzer does not operate normally | Does not operate |
| Check seat buzzer Refer to Component Function Check. | ||
| Does not stop |
| ||||
Removal and Installation
CAUTION:
REMOVAL
Remove front bumper fascia. Refer to following.
City model: Removal and Installation.
Off road model: Removal and Installation.
Disconnect front fog lamp harness connector.
Remove front fog lamp mounting bolts, and then remove front fog lamp.
INSTALLATION
Note the following item, ...
Inspection
INSPECTION AFTER REMOVAL
Appearance
Check the following items, and replace the part if necessary.
Lower link for deformation, cracks or damage.
Bushings for complete seperation. (If completely seperated, inner metal can be pulled out from lower link.)
Ball joint boot for cracks or other damage, and ...
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension System.
When checking under the vehicle or in ...