Removal & Installation
REMOVAL
Remove the map lamp assembly. Refer to Removal and Installation.
Remove the microphone harness connector 
.
Use a suitable tool to release pawl and remove the switch finisher 
.
 |
: Pawls |
CAUTION:
Do not damage pawl.
Use a suitable tool to release pawls and remove the moonroof switch assembly (telematics switch) .
|
: Pawls |
CAUTION:
Do not damage pawl.
INSTALLATION
Installation is the reverse order of removal.
NOTE:
Check the telematics switch for looseness after the installation.
Other materials
Basic information
WARNING
Never operate your Nissan Armada while the parking brake is engaged.
Driving with the parking brake applied can cause overheating, reduced braking
performance, and eventual brake failure, significantly increasing the risk of
an accident.
Do not release the parking brake of you ...
Repairing Material
Foam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...
Both Side Front Fog Lamps Are Not Turned on
Description
Both side front fog lamps are not turned ON in any condition.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK FRONT FOG ...