Description
Both side front fog lamps are not turned ON in any condition.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning part.
CHECK FRONT FOG LIGHT REQUEST SIGNAL
With CONSULT
-
Select “Front fog lamp request” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
-
With operating the front fog lamp switch, check the monitor status.
Monitor item Condition Monitor status Front fog lamp request Front fog lamp switch
(With lighting switch 2ND)ON On OFF Off
Is the item status normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
Transfer Cam Position Sensor
Exploded View
Transfer assembly
Transfer cam position sensor
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspe ...
Front Fog Lamp Aiming Adjustment
Adjustment
PREPARATION BEFORE ADJUSTINGNOTE:
For details, refer to the regulations in your own country.Before performing aiming adjustment, check the following.
Adjust the tire pressure to the specification.
Fill with fuel, engine coolant, and each oil.
Maintain the unloaded vehicle condition. ...
Additional Service When Replacing Around View Monitor Control Unit
Description
CAUTION:
When replacing the around view monitor control unit, always replace it with a new one. Around view monitor system does not operate properly in case of reuse of the around view monitor control unit from another vehicle.
When before writing the around view monitor control unit ...