Description
After working the following, transfer unit parameter must be written to transfer control unit.
-
Transfer control unit replacing
-
Transfer assembly replacing
-
Transfer control actuator replacing
-
Transfer range position sensor replacing
-
Transfer cam position sensor replacing
-
Transfer case component parts disassembling
NOTE:
Write charactereistic value in transfre control unit, if the above each parts is replaced.
For the work procedure, refer to Work Procedure.
Work Procedure
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.
 |
: Side surface |
 |
: Top surface |
NOTE:
There is space on the top to check with the camera.
>>
GO TO 2.
WRITING UNIT PARAMETER
With CONSULT
-
Ignition switch ON.
-
Select “Work support” in “AWD/4WD”.
-
Perform “Unit parameter writing” to the CONSULT display.
>>
WORK END
Other materials
Transfer: Atx93c Tools and Preparation
Preparation
Commercial Service Tools
Tool name Description
Drift
a: 61.0 mm (2.402 in) dia.
b: 56.3 mm (2.217 in) dia.
Installing front oil seal
Drift
a: 68.0 mm (2.677 in) dia.
b: 47.0 mm (1.850 in) dia.
Installing rear oil seal
Drift
a: 68.6 mm (2.701 in) dia.
b: 58.0 mm (2.28 ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...
Rear Wiper
Exploded View
Rear wiper motor
Rear wiper blade
Rear wiper arm
Pivot seal
: N·m (kg-m, in-lb)
...