Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.
WORK AFTER REPLACEMENT
-
Unit parameter writing
-
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
-
Ignition switch ON.
-
Select "AWD/4WD".
-
Select "Replace ECU".
-
Perform the work according to the procedure displayed in CONSULT.
CAUTION:
The following conditions must be maintained during ECU modernization procedure.
-
Ignition switch ON.
-
All electric loads are OFF
-
Brake pedal is not depressed.
-
Battery voltage: 12-13.5 V (Be sure to check the value of battery voltage by CONSULT.)
NOTE:
Writing of control unit information is performed automatically.
-
>>
GO TO 2.
WRITING UNIT PARAMETER
Perform writing of the unit parameter to transfer control unit. Refer to Work Procedure.
>>
GO TO 3.
INITIAL CALIBRATION
-
Continue the following condition.
Transmission position : P
4WD mode : AUTO
-
Depress the brake pedal.
-
Start the engine and wait for approximately 10 seconds under the brake pedal depressed.
>>
GO TO 4.
PERFORM SELF-DIAGNOSIS
With CONSULT
-
Erase self-diagnostic results for “AWD/4WD”.
-
Ignition switch ON to OFF.
CAUTION:
Wait for 60 seconds after ignition switch OFF.
-
Depress the brake pedal.
-
Start the engine.
CAUTION:
Never drive the vehicle.
-
Perform self-diagnosis for “AWD/4WD”.
Is any DTCs detected?
YES>>Check DTC detected item. Refer to DTC Index.
NO>>WORK END
Other materials
Meters and gauges
Basic information
Example
The instrument cluster in the Nissan Armada is designed to provide clear, real-time
information about vehicle performance and status. It combines modern digital displays
with traditional gauges to ensure the driver can monitor all critical systems efficiently.
...
Front Oil Seal
Exploded View
Drive pinion lock nut
Companion flange
Front oil seal
Front final drive assembly
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to ...
Passenger Side
Description
Passenger door does not lock/unlock using door lock and unlock switch.
Diagnosis Procedure
CHECK DOOR LOCK ACTUATOR
Check door lock actuator (passenger side).
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctio ...