Nissan Armada 2025-2026 Service and Repair Manual: Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
CAUTION:
>>GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by the interview. Also check that the symptom is not caused by fail-safe mode. Refer to Fail-safe.
CAUTION:
>>GO TO 3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “CHASSIS CONTROL”.
Is DTC detected?
YES>>Record or print self-diagnosis results and freeze frame data (FFD). GO TO 4.
NO>>INSPECTION END
PERFORM DTC DIAGNOSIS PROCEDURE
With CONSULT
Perform DTC confirmation procedures for the error-detected system.
NOTE:
Is DTC detected?
YES>>GO TO 5.
NO>>Check harness and connectors based on the information obtained by the interview.
REPAIR OR REPLACE ERROR-DETECTED PARTS
Repair or replace error-detected parts.
Reconnect part or connector after repairing or replacing.
When DTC is detected, erase self-diagnosis results for “CHASSIS CONTROL”.
GO TO 6.
FINAL CHECK
With CONSULT
Check the reference value for “CHASSIS CONTROL”.
Is the symptom reproduced?
YES>>GO TO 3.
NO>>INSPECTION END
Diagnostic Work Sheet
Description
In general, customers have their own criteria for a symptom. Therefore, it is important to understand the symptom and status well enough by interviewing the customer about the symptom care ...
Other materials:
Exploded View
Front Foot Lamp (LH)
Steering member assembly Front foot lamp bracket (LH) Front foot lamp (LH) : Pawl : Vehicle front
Front Foot Lamp (RH)
Front foot lamp (RH) Front foot lamp bracket (RH) Passenger knee air bag module : Pawl : Vehicle front ...
Steering Gear and Linkage
Item Standard
: Gear housing end
: Inner socket end Rack stroke neutral position (C) 27.5 mm (1.083 in) Rack stroke full stroke position (C) 154 mm (6.06 in) Outer socket ball joint Swing force* (Spring balance measurement) 14.0 – 40.6 N (1.43 – 4.14 kgf, 3.15 – 9.12 lbf) Ball joint ...
Inspection
DRIVE PLATE DEFLECTION
Appearance of Drive Plate
Check the drive plate and signal plate for defamation or damage.
CAUTION:
Do not disassemble drive plate.
Do not place drive plate with signal plate facing down.
When handling signal plate, take care not to damage or scratch it.
Handle signal pla ...
0.005