Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
CHECK DTC
Check DTC.
Is any DTC detected?
YES>>Repair malfunction(s) and erase DTC.
NO>>GO TO 2.
CHECK PERMANENT DTC
With CONSULT
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Select “PERMANENT DTC STATUS” mode with CONSULT.
With GST
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Select Service $0A with GST.
Is any permanent DTC detected?
YES>>GO TO 3.
NO>>END
HOW TO ERASE PERMANENT DTC
CAUTION:
Always drive at a safe speed.
Perform "DTC CONFIRMATION PROCEDURE "of detected permanent DTC.
Drive the vehicle following to driving pattern.
The state of driving at 40 km/h (25 MPH) reaches 300 seconds or more in total.
Idle speed lasts 30 seconds or more.
A lapse of 600 seconds or more after engine start.
GO TO 4.
CHECK PERMANENT DTC
With CONSULT
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Select “PERMANENT DTC STATUS” mode with CONSULT.
With GST
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Ignition switch OFF and wait at least 60 seconds.
Ignition switch ON.
Select Service $0A with GST.
Is any permanent DTC detected?
YES>>GO TO 1.
NO>>END
How to Erase Pearmanent Dtc
WHEN A DTC IS STORED IN TCM
When a DTC is stored in TCM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL s ...
Other materials:
STEERING ASSIST SWITCH : Removal & Installation
REMOVAL
Remove instrument pad A.Refer to Removal and Installation.
Remove mounting screws , and remove switch panel from instrument pad A .
Unhook the pawls to remove the switch from the switch panel .
INSTALLATION
Installation is in the reverse order of removal. ...
Symptom Table
REAR VIEW MONITOR
Symptoms Possible cause Inspection item Camera image is not shown.
(Vehicle width and predictive course line are displayed.) Harness between rear view camera and AV control unit
Rear view camera
AV control unit
Display unit
Perform “Self Diagnostic Result” of “MULTI AV" ...
Disassembly and Assembly
CAUTION:
OUTSIDE SEAT CUSHION FINISHER OUTER
Disassembly
Disengage fixing pawls, and then remove reclining knob cap.
: Pawl
Disengage fixing portion using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove reclining knob.
Remove ...
0.0052