Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT

Replace driving video recorder control module. Refer to Removal and Installation.

>>

GO TO 2.

WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE

With CONSULT

  1. Ignition switch ON and wait at least 5 seconds.

  2. Select “Write vehicle identification number (manual input)” of “Work support” item using CONSULT.

  3. Touch “Start” at “Write vehicle identification number (manual input)” screen to write the VIN data into new driving video recorder control module.

>>

GO TO 3.

DRIVING RECORDER INITIALIZATION

  1. Touch to display the settings menu, and then touch "Dash Cam".

  2. Touch "Reset All DashCam Settings to Default" in "System" to reset the driving recorder settings.

>>

GO TO 4.

PERFORM DRIVING VIDEO RECORDER CONTROL MODULE CONFIGURATION

With CONSULT

Touch "Replace ECU" of CONSULT, Perform driving video recorder control module configuration according to CONSULT.

>>

GO TO 5.

PERFORM SELF-DIAGNOSIS

With CONSULT

  1. Perform a self-diagnosis for “Driving Video Recorder”. Refer to CONSULT Function.

  2. Check DTC.

Are any DTCs detected?

YES>>

Perform the trouble diagnosis for detected DTCs. Refer to DTC Index.

NO>>

WORK END

Additional Service When Replacing Driving Video Recorder Control Module
...

Recorder System — Symptom Diagnosis
...

Other materials:

Inspection
WARNING: FLUID LEAKAGE FLUID LEVEL CAUTION: Never start engine while checking fluid level. Install filler plug on transfer and then tighten to the specified torque. CAUTION: Never reuse filler plug. Specified torque : 37.5 N·m (3.8 kg-m, 28 ft-lb) ...

Draining
WARNING: The ignition switch OFF. Remove engine under cover. Refer to Exploded View. Remove drain plug and gasket. Drain gear oil. Set a gasket on drain plug and install it to final drive assembly. CAUTION: Never reuse gasket. Tighten drain plug to the specified torque. Refer to Exploded View. I ...

System maintenance
Example Basic information The two radar sensors A for the I-BSI system are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as snow, splashing water, mist or fog. The blocked condition ma ...

© 2014-2026 Copyright www.niarmada.com
 
0.0052