Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

• Perform action test to verify the customer's concern.

• Perform action test and check the system operation after system diagnosis.

CAUTION:

Fully understand the following items well before the road test;

CHECK BSW SYSTEM SETTING

1. Start the engine, and then wait for 30 seconds or more.

2. Check that the BSW system setting can be enabled/disabled on the information display.

3. Turn OFF the ignition switch and wait for 5 seconds or more.

4. Check that the previous setting is saved when the engine starts again.

GO TO 2.

BSW SYSTEM ACTION TEST

1. Turn BSW system ON.

2. Check BSW operation according to the following table.

   Condition				Action	Indication on the BSW indicator	Display on information display	Buzzer
   BSW OFF				—	OFF		OFF
   BSW ON	Vehicle speed is less than approx. 32 km/h (20 MPH)			—	OFF	BSW system indicator : White Speaker icon : White	OFF
   	Vehicle speed is approx. 32 km/h (20 MPH) or more	Vehicle is not detected		—	OFF	BSW system indicator : White Speaker icon : White	OFF
   		Vehicle is detected	Turn signal is OFF	—	ON	BSW system indicator : White Speaker icon : White	OFF
   		Vehicle is detected before turn signal operates	Turn signal is ON (vehicle detected direction)	—	Blink	Yellow (Blink)	Short continuous beeps
   						BSW system indicator : Yellow (Blink) Speaker icon : White
   		Vehicle is detected after turn signal operates	Turn signal is ON (vehicle detected direction)	—	Blink	Yellow (Blink)	OFF
   						BSW system indicator : Yellow (Blink) Speaker icon : White

   NOTE:

   If vehicle speed exceeds approximately 32 km/h (20 MPH), BSW function operates until the vehicle speed becomes lower than approximately 29 km/h (18 MPH).

INSPECTION END

© 2014-2026 Copyright www.niarmada.com

 
0.0078