Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Disconnect the transfer cam position sensor connector.
Remove the transfer cam position sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
Never damage the O-ring of position sensor.
Never contaminate or damage the O-ring mounting surface.
Exploded View
Transfer assembly Transfer cam position sensor : N·m (kg-m, in-lb) ...
Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
When replacing transfer cam position sensor, performe writing unit parameter. ...
Other materials:
Welding of Ultra High Strength Steel
SPOT WELDING
Spot welding is limited to ultra high strength steel (tensile strength: 980 MPa) according to the welding conditions listed below.
CAUTION:
If the below welding conditions cannot be met, then perform plug welding.
Never spot weld ultra high strength steel of tensile strength more than 9 ...
Work Procedure (Group A)
*1: When the same malfunction is detected in two consecutive trips, MIL will illuminate.
CHECK DTC
Check DTC.
Is any DTC detected?
YES>>
Repair malfunction(s) and erase DTC.
NO>>
GO TO 2 .
CHECK PERMANENT DTC
With CONSULT
Ignition switch OFF and wait at least 10 seconds.
Ignitio ...
Precautions on seat belt usage
When seated properly in the Nissan Armada, with your seat belt correctly adjusted,
your back positioned firmly against the seat and both feet placed on the floor,
the risk of serious injury or fatal consequences in an accident can be significantly
reduced. The Nissan Armada is equipped with ad ...
0.0048