Description
After replaced A/C auto amp. it is necessary to perform control unit configuration with CONSULT. For details, refer to Work Procedure.
AFTER REPLACEMENT
CAUTION:
-
When replacing A/C auto amp. write vehicle specification with CONSULT vehicle configuration.
-
Never perform vehicle configuration other than performing with new A/C auto amp. or the control function may not operate normally.
Work Procedure
REPLACE A/C AUTO AMP.
Replace A/C auto amp. Refer to Removal and Installation.
>>
GO TO 2.
WRITING vehicle SPECIFICATION
Perform configuration (HVAC). Refer to Description.
>>
WORK END
Other materials
Auto Door Lock Operation Does Not Operate. Automatic Back Door Control Unit
Automatic Back Door Control Unit
Diagnosis Procedure
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES>>
INSPECTION END
NO>>
Check intermittent incident. Refer to Inter ...
Both Side Headlamps (lo) Are Not Turned on
Description
Both side headlamps (LO) are not turned ON in any condition.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK LOW BEAM ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...