Work Procedure
Work ProcedureRear Floor Rear
WARNING:
WITH ProPILOT Assist 2.1 MODELS
Work after rear end crossmember is removed.
: Vehicle front : Drill φ6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel). : Drill φ7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel). : Weld the parts onto the ba ...
Diagnosis Procedure
CHECK DTC WITH BACK DOOR AUTO CLOSURE CONTROL UNIT
Check that DTC is not detected with back door auto closure control unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK BACK DOOR OPENER SWITCH
Check back door opener switch.
Refer to Component Function ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...