Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precautions
...
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
System
WARNING:
CAUTION:
OPERATION PROCEDURE
Jacking up or lift up using the following steps.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Jacking up or lif ...
Other materials:
Key Points in Actual Repair Work
CAUTION:
Illustration shows a badly damaged side member for clarity. Badly damaged or kinked side rails must always be replaced.
(1) STRETCHING SHRUNK PORTIONS
The repair of a bent closed cross-sectional structure, such as a side member, is done by clamping the surface of the bent-in side and pullin ...
Parts to be Replaced
High-strength steel parts: The strength of these parts will be reduced if repaired by heating.
Parts relating to body alignment and wheel alignment: Replacement of such parts would not provide proper alignment.
When repair costs exceed replacement cost.
Availability of service parts.
When asked by c ...
Work Procedure
WARNING:
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.
: Side surface : Top surface
NOTE:
There is space on the top to check with the camera.
>>
GO TO 2.
WRITING ...
0.0084