NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Air Suspension Control Module

Nissan Armada 2025-2026 Service and Repair Manual / Suspension / Suspension Control System. Electronic Air Suspension / Additional Service When Replacing Air Suspension Control Module

Work Procedure

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the air suspension contorol module.

For details the operation, refer to “CONSULT Operation Manual”.

Work Procedure

WRITING VEHICLE SPECIFICATION AND VIN

With CONSULT

Perform writing vehicle specification to air suspension control module according to "Replace ECU" in CONSULT Operation Manual.

NOTE:

  • Ignition switch ON or engine start during writing the vehicle specification and VIN.

  • When "Replace ECU" is performed, VIN registration is completed at the same time. Check that U1A76-55 of "Current DTC" switched to one of "Past DTC".

>>

GO TO 2.

PERFORM NECESSARY WORK

With CONSULT

  1. Select "Air suspension" and perform "Work support" in the following order. Refer to Work Support.

    1. Venting valve operation check

    2. Air filling/pressure measurement

    3. Height sensor calibration

    4. vehicle height adjustment

  2. Perform self-diagnosis for “All self diagnosis result”.

  3. Erase the memory of self-diagnosis results.

>>

WORK END

    Other materials

    Event Data Recorders (EDR)
    Basic information Your Nissan Armada is equipped with an Event Data Recorder (EDR), a system designed to capture critical vehicle data during specific crash or near-crash situations. These events may include airbag deployment or impact with road obstacles. The primary function of the EDR is to ...

    Second Heated Seat System
    Symptom Table Symptom Possible causeInspection item Second heated seat system does not operate Display unit and rear A/C control operation does not operate Fuse Second seat heater power supply/ground/LIN signal circuit Second seat cushion heater Second seatback heater A/C auto amp. Check second ...

    Calibrating Camera Image (around View Monitor)
    3d Fixed View Work Procedure Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the around view monitor control unit. The use of CONSULT is required to perform calibration or writin ...