Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Bcm

Work Flow

OVERALL SEQUENCE DETAILED FLOW INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. To do so, reproduce the symptom before hand and fully understand it. Then interview the custo ...

Work Procedure

ADDITIONAL SERVICE WHEN REPLACING BCM Perform additional service when replacing BCM. Refer to Description. >> GO TO 2. PERFORM TIRE PRESSURE SENSOR ID REGISTRATION Perform tire pressure sensor ...

Other materials:

Body Center Marks
Factory marks exist on certain parts of the body to indicate the vehicle center. When repairing the vehicle frame (members, pillars, etc.) damaged in an accident, the most accurate and effective repair will be achieved by using these marks together with body alignment specifications. : Vehicle fron ...

When SRS is not activated in a collision
CAUTION: WORK PROCEDURE Check the SRS components using the table below. Ensure entire SRS operates properly. SRS INSPECTION (FOR REAR COLLISION) Part Inspection Driver air bag module If the driver air bag has not been activated: Remove driver air bag module. Check harness cover and connectors fo ...

Calibration of Decel G Sensor
TCM stores calibration data (inherent characteristic value) of decel G sensor to provide accurate control. Decel G sensor calibration must be performed when the following operation is performed. For work procedure, refer to Work Procedure. Removing/Installing yaw rate/side/decel G sensor Replacing y ...