Work Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor Camera".
Is the inspection result normal?
YES>>GO TO 3.
NO>>Check installation status of the driver monitor camera control unit (installation position, specified tightening torque, bending of bracket, etc.).
PERFORM SELF-DIAGNOSIS
Check that DTC is detected in self-diagnosis result of "Driver Monitor Camera".
Is DTC detected?
YES>>Perform a diagnosis of detected DTC and repair or replace the malfunction parts. Refer to DTC Index.
NO>>WORK END
Other materials
Instrument Panel Assembly
Exploded View
INSTRUMENT PANEL ASSEMBLY
Front speaker grille*1
Display unit cover
Display unit
Instrument panel assembly
Instrument mask LH
Instrument finisher A
Display unit finisher LH
Instrument pad A
Steering column cover upper
Steering column cover lower
Instrum ...
Intelligent Key System Symptoms
Diagnosis Procedure
NOTE:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) No. Door lock operation (remote keyless entry) Door lock operation (request switch of ...
Rear Wiper Motor
Removal and Installation
REMOVALRemove rear wiper arm. Refer to Removal and Installation.
Disconnect rear wiper motor harness connector and remove harness clip .
Remove rear wiper motor mounting bolts , and then remove rear wiper motor.
CAUTION:
Never drop rear wiper motor or cause it to come in ...