Description
Each function is reset to the following condition when the driver seat control unit is replaced. For details, refer to Work Procedure.
| Function | Condition | Procedure |
|---|---|---|
| Memory (Seat, steering column, door mirror) | Erased | Perform memory storing |
| Log-in | Erased | Perform log-in storing |
Work Procedure
REPLACE DRIVER SEAT CONTROL UNIT
Replace driver seat control unit. Refer to Removal and Installation.
>>
GO TO 2.
vehicle SPECIFICATION RECOGNITION
Connect battery negative terminal. Power switch ON and wait for 30 seconds or more.
NOTE:
When the driver seat control unit receives a signal from the AV control unit for 30 seconds after the battery is energized, it is recognized and set as the specifications of with navigation system.
>>
GO TO 3.
LOG-IN STORING
Perform log-in storing. Refer to System Description.
>>
GO TO 4.
MEMORY STORING
Perform memory storing. Refer to Description.
>>
WORK END
Other materials
Transfer Control Actuator
Exploded View
Transfer assembly
Transfer control actuator
bracket
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer t ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.
SUSPECTED PARTS
(Possible cause) Symptom Reference
Transfer fluid leakage Noise
TRANSFER FLUID (Level low)
1 ...
Fuel Lines
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
Inspect fuel lines ...