Exploded View

![]() |
Transfer assembly | ![]() |
Transfer control actuator | ![]() |
bracket |
![]() |
: N·m (kg-m, in-lb) |
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector
.

Remove harness clip
.

Remove transfer control actuator mounting bolt (
) and remove bracket
.

Remove transfer control actuator
.

INSTALLATION
Note the following, and install in the reverse order of removal.
-
Never damage oil seal of transfer control actuator.
-
Never contaminate or damage the oil seal mounting surface.
-
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER REMOVAL
Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.
Check the transfer assembly as follows.Install the suitable tool (A) to transfer assembly as shown in the figure.

, check returning to direction
by spring power.
CAUTION:
The maximum turning force shall be 5 N·m (0.51 kg-m, 44 in-lb).
When turn the shaft in direction
, check locking the shaft. INSPECTION AFTER INSTALLATION
After driving, check the surface fitting transfer control actuator to transfer assembly for fluid leakage.
ADJUSTMENT AFTER INSTALLATION
When replacing transfer control actuator, performe writing unit parameter. Refer to Description.
Other materials
Battery
Basic information
On the Nissan Armada, batteries labeled "do not open" are fully maintenance-free,
meaning the internal electrolyte level does not require inspection. For accurate
diagnostics and performance checks, it is strongly recommended to consult an
authorized NISS ...
Curtain Air Bag Module
Exploded View
Curtain airbag module
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 mi ...
Without Automatic Drive Positioner
Diagnosis Procedure
CHECK DOOR MIRROR MECHANISM
Check the following items.
Damage, deformation and foreign matter pinching of the door mirror mechanism.
Damage of harness due to rubbing and pinching.
Interference with other components.
Installed incorrectly.
Is the inspection result normal ...


