Work Procedure
Description
When replacing or removing the Head Up Display unit, distortion calibration of the display and adjustment of the display position are required.
Work Procedure
REPLACE HEAD UP DISPLAY UNIT
Replace Head Up Display unit. Refer to Removal and Installation.
>>
GO TO 2.
PERFORM CALIBRATION
Perform Head Up Display calibration. Refer to Work Procedure.
>>
GO TO 3.
ADJUST DISPLAY SCREEN
Adjust display screen position. Refer to Switch Name and Function.
>>
GO TO 4.
OPERATION CHECK
Check the display of Head Up Display.
Is the displayed normal?
YES>>WORK END
NO>>Perform display adjustment again. GO TO 3.
Other materials
Additional Service When Replacing Transfer Control Unit
Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.WORK AFTER REPLACEMENT
Unit parameter writing
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignitio ...
Noise, Vibration, and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
Vibration Shake Noise
Uneven rotating torque
×
×
Inspection
Center bearing improper installation
× ...
Entry Assist/driving Position Return Function Does Not Operate
Diagnosis Procedure
CHECK LOG-IN FUNCTION
Check log-in function. Refer to System Description.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to Work Flow.
CHECK REMOTE KEYLESS ENTRY FUNCTION
Check door lock/unlock using Intelligent Key button operation.
Does door lock/unloc ...