Description
When replacing occupant detection system control unit or removing and installing passenger seat, always perform zero point reset so that occupant detection system is activated normally. Refer to Work Procedure.
Work Procedure
PERFORM ZERO POINT RESET
Perform zero point reset. Refer to Description.
>>
WORK END
Other materials
Front Propeller Shaft
Exploded View
REMOVAL
Propeller shaft assembly
: vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
DISASSEMBLY
Snap ring
Journal bearing
Journal
Flange yoke
Propeller shaft tube
: Select with proper thickness. ...
Front Door Check Link
Removal and Installation
REMOVALFully close front door glass.
Remove front door woofer. Refer to Removal & Installation.
Remove front door check link mounting bolt of vehicle body side.
Remove front door check link mounting bolts of front door panel, and then take front door check link out from ...
Rear Wiper
Exploded View
Rear wiper motor
Rear wiper blade
Rear wiper arm
Pivot seal
: N·m (kg-m, in-lb)
...