NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Transfer Control Unit

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Driveline. Transfer: Atx93a / Additional Service When Replacing Transfer Control Unit

Description

When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.

WORK AFTER REPLACEMENT

  • Unit parameter writing

  • Initial calibration

Work Procedure

WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT

With CONSULT

  1. Ignition switch ON.

  2. Select "AWD/4WD".

  3. Select "Replace ECU".

  4. Perform the work according to the procedure displayed in CONSULT.

    CAUTION:

    The following conditions must be maintained during ECU modernization procedure.

    • Ignition switch ON.

    • All electric loads are OFF

    • Brake pedal is not depressed.

    • Battery voltage: 12-13.5 V (Be sure to check the value of battery voltage by CONSULT.)

    NOTE:

    Writing of control unit information is performed automatically.

>>

GO TO 2.

WRITING UNIT PARAMETER

Perform writing of the unit parameter to transfer control unit. Refer to Work Procedure.

>>

GO TO 3.

INITIAL CALIBRATION

  1. Continue the following condition.

    Transmission position : P

    4WD mode : AUTO

  2. Depress the brake pedal.

  3. Start the engine and wait for approximately 10 seconds under the brake pedal depressed.

>>

GO TO 4.

PERFORM SELF-DIAGNOSIS

With CONSULT

  1. Erase self-diagnostic results for “AWD/4WD”.

  2. Ignition switch ON to OFF.

    CAUTION:

    Wait for 60 seconds after ignition switch OFF.

  3. Depress the brake pedal.

  4. Start the engine.

    CAUTION:

    Never drive the vehicle.

  5. Perform self-diagnosis for “AWD/4WD”.

Is any DTCs detected?

YES>>

Check DTC detected item. Refer to DTC Index.

NO>>

WORK END

    Other materials

    Headlight and turn signal switch
    Headlight switch Basic information CAUTION In the Nissan Armada, always operate the headlights with the engine running to prevent unnecessary battery discharge and ensure reliable electrical system performance. Example Lighting Type A (if so equipped): Rotate the switch to the ...

    A/c Auto Amp.
    Exploded View Front blower unit assembly A/C auto amp.     : vehicle front Removal and Installation REMOVAL2WD ModelsRemove glove box assembly. Refer to Removal and Installation. Remove passenger knee air bag module. Refer to Removal and Installation. Disconnect A/C auto amp. ...

    Back Door Touch Sensor
    Removal and Installation REMOVALRemove back door inner finisher. Refer to Removal and Installation. Disconnect back door touch sensor harness connector . Remove back door touch sensor fixing clips. : Clip Remove harness grommet from back door panel, and then pull out back door touch sensor ...