NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Unit Parameter Writing

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Driveline. Transfer: Atx93a / Unit Parameter Writing

Description

After working the following, transfer unit parameter must be written to transfer control unit.

  • Transfer control unit replacing

  • Transfer assembly replacing

  • Transfer control actuator replacing

  • Transfer range position sensor replacing

  • Transfer case component parts disassembling

NOTE:

Write charactereistic value in transfre control unit, if the above each parts is replaced.

For the work procedure, refer to Work Procedure.

Work Procedure

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

UNIT CHARACTERISTIC VALUE CONFIRMATION

Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.

: Side surface
: Top surface

NOTE:

There is space on the top to check with the camera.

>>

GO TO 2.

WRITING UNIT PARAMETER

With CONSULT

  1. Ignition switch ON.

  2. Select “Work support” in “AWD/4WD”.

  3. Perform “Unit parameter writing” to the CONSULT display.

>>

WORK END

    Other materials

    Front Suspension Assembly
    Inspection WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System. COMPONENT PARTCheck ...

    Tire Pressure Sensor Id Registration
    Description This procedure must be performed. After replacement of a tire pressure sensor or BCM. After replacement of tire or road wheel. NOTE: ID registration is unnecessary if there are no change in the positions of each wheels (tire pressure sensors) before wheel removal and after wheel inst ...

    Ign Off Interlock Door Unlock Function Does Not Operate
    Diagnosis Procedure CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER Check “Auto Door Unlock” setting is “Ignition OFF”. Is the inspection result normal? YES>> GO TO 2. NO>> Set “IGN OFF” in combination meter. REPLACE BCM Replace BCM. Refer to Removal and Install ...