WARNING:
When replacing the transmission assembly, perform the following work. For work procedure, refer to Work Procedure.
WORK AFTER TRANSMISSION ASSEMBLY REPLACEMENT
Vehicle specifications writing
CAUTION:
Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT.
Calibration of decel G sensor
Diagnostic Work Sheet
Work ProcedureMeasurement with Manual Gauges
(1) MEASUREMENT WITH TRACKING GAUGES
Three types of deformations, side-sway, diamond and buckling, can be measured.
(a) Side-sway
This is checked by measuring the dimensions of the respective crossmember diagonal lines and comparing them to see if any differences are present.
(b) Diamond
Measure ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Driver and front passenger supplemental knee air bag
Driver's side
In the Nissan Armada, the supplemental knee air bags are strategically positioned
within the lower dashboard area, also known as the knee bolster, on both the driver
and front passenger sides. These systems are an integral part of the overall Supplemental
Restraint Syste ...