WARNING:
CAMBER
Adjust with adjusting bolt
in front lower link.

| Camber | Refer to Wheel Alignment. |
CAUTION:
When tightening the nut firmly and checking the torque, use a wrench to prevent the turning of bolt.
After adjusting camber, be sure to check toe-in.
After adjusting camber, be sure to perform the height sensor calibration. Refer to Work Support.
If camber is not still within the specification, inspect and replace any damaged or worn suspension parts.
TOE-IN
Adjust with adjusting bolt
in rear lower link.

| Toe-In | Refer to Wheel Alignment. |
CAUTION:
Be sure to adjust equally on right and left side with adjusting bolt.
When tightening the nut firmly and checking the torque, use a wrench to prevent the turning of bolt.
After adjusting toe-in, be sure to perform the height sensor calibration. Refer to Work Support.
If toe-in is not still within the specification, inspect and replace any damaged or worn suspension parts.
InspectionInspection and Adjustment
SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing rear door regulator assembly. Refer to Work Procedure.
FITTING INSPECTION
Check that the glass is fitted securely into the sash groove.
Lower the glass slightly [approximately 10 ...
Removal and Installation
WARNING:
REMOVAL
Remove valve timing control covers (bank 1 and bank 2). Refer to Removal & Installation.
Remove electric intake valve timing control actuator (bank 1 and bank 2). Refer to Removal & Installation.
Remove crankshaft pulley. Refer to Removal & Installation.
Remove front cov ...
How to enable/disable the I-BSI system
Example
ProPILOT Assist switch (design may vary depending on the Nissan Armada model)
Vehicle information display
Steering-wheel-mounted control (right side)
To configure the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system,
follow these steps:
1. Press the
butt ...