Description
CAUTION:
When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "Initialization position adjustment" of "Work support". Refer to Work Procedure.
×: Required —: not required
| Procedure | Initialization position adjustment |
|---|---|
| Removing/ installing ABS actuator and electric unit (control unit) | — |
| Replacing ABS actuator and electric unit (control unit) | × |
| Removing/ installing rear brake pad (When not pressing piston of rear brake caliper assembly) | — |
| Removing/ installing rear brake pad (When pressing piston of rear brake caliper assembly) | — |
| Replacing rear brake pad | × |
| Removing/ installing rear brake caliper assembly | — |
| Replacing rear brake caliper assembly | × |
| Removing/ installing parking brake switch | — |
| Replacing parking brake switch | — |
Work Procedure
PERFORM INITIALIZATION POSITION ADJUSTMENT
-
Select "ABS", "Work support", and "Initialization position adjustment" according to this order.
CAUTION:
-
Never operate the parking brake switch.
-
Never depress the brake pedal.
-
-
Touch "START".
>>
GO TO 2.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
-
Ignition switch OFF (Auto ACC function OFF) to ON.
-
Erase self-diagnosis results memory of "ABS".
-
Pull parking brake switch to activate electric parking brake.
-
Push parking brake switch to release electric parking brake.
-
Perform self-diagnosis for “ABS”.
Is malfunction detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>INSPECTION END
Other materials
Additional Service When Replacing Sub-Tcm
Description
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
When replacing the ...
Front Fender
Removal and Installation
REMOVALRemove fender cover. Refer to Removal and Installation.
Remove front fender drip cover. Refer to Removal and Installation.
Remove front combination lamp and head lamp. Refer to Removal and Installation.
Remove front fender protector. Refer to Removal and Installation. ...
Squeak and Rattle Trouble Diagnoses
Work Flow
CUSTOMER INTERVIEW
The customer may not be able to provide a detailed description or the location of the noise. Attempt to obtain all the facts and conditions that exist when the noise occurs (or does not occur).
If there is more than one noise in the vehicle, perform a diagnosis and re ...