Symptom Description
Without ProPILOT Assist 2.1
The AEB OFF warning lamp is blinking. Refer to Diagnosis Procedure.
NOTE:
When any of the following conditions, the AEB OFF warning lamp blinks:
-
The distance sensor area of the front of the vehicle is covered with dirt or is obstructed
-
The interior temperature of the vehicle is extremely high
-
The windshield is dirty, frosted, fogged up, or damaged in front of the front camera unit
-
The front camera unit or the front camera unit bracket is not mounted properly
With ProPILOT Assist 2.1
The AEB OFF warning lamp is blinking. Refer to Diagnosis Procedure.
NOTE:
When any of the following conditions, the AEB OFF warning lamp blinks:
-
The distance sensor area of the front of the vehicle is covered with dirt or is obstructed
-
The interior temperature of the vehicle is extremely high
-
The windshield is dirty, frosted, fogged up, or damaged in front of the driver assistance camera
-
The driver assistance camera or the driver assistance camera bracket is not mounted properly
Diagnosis Procedure
Without ProPILOT Assist 2.1
CHECK THE WINDSHIELD
Check if the windshield is dirty, frosted, fogged up, or damaged in front of the front camera unit.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Clear, clean, or repair the windshield as needed. Refer to Removal and Installation.
CHECK THE FRONT CAMERA UNIT AND FRONT CAMERA UNIT BRACKET INSTALL CONDITION
Check if the front camera unit and the front camera unit bracket are mounted properly.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Correct improper mounting.
With ProPILOT Assist 2.1
CHECK THE WINDSHIELD
Check if the windshield is dirty, frosted, fogged up, or damaged in front of the driver assistance camera.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Clear, clean, or repair the windshield as needed. Refer to Removal and Installation.
CHECK THE DRIVER ASSISTANCE CAMERA AND DRIVER ASSISTANCE CAMERA BRACKET INSTALL CONDITION
Check if the driver assistance camera and the driver assistance camera bracket are mounted properly.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Correct improper mounting.
Other materials
Vr35ddtt
Exploded View
Transmission housing
Starter motor cover 1
Starter motor cover 2
“B” terminal harness
Starter motor harness connector
Starter motor
: vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Indicates that the part is connected at points with same s ...
Additional Service When Replacing Electric Shift Selector
Description
When electric shift selector is replaced, always perform "Replace ECU" of CONSULT function to write vehicle specifications. For work procedure, refer to Work Procedure.
Work Procedure
WRITING VEHICLE SPECIFICATIONS
With CONSULT
Ignition switch ON.
Select "ELECTRIC SHIFTER".
Select ...
Transfer Assembly
Exploded View
Transfer assembly
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Li ...